Polyurethane Corbels Installation
Corbels add an extra facet of architectural ornaments to archways, cornices and even fine kitchen cabinetry. Corbels made from high-density furniture grade polyurethane. Our corbels are exquisitely detailed from hand-crafted molds insuring a quality product every time. All corbels can be finished with either latex oil base paint.
Tools and Material for corbels installation- Sponge or clean cloth.
- Caulking gun.
- Elastomeric adhesive caulk.
Optional Tools and Material for Corbels Installation:
- Putty knife.
- Hammer and nail set.
- 6d or 8d finishing nails (bright finish or electro-galvanized) fasteners must penetrate substrate a min. of 1/2 to 3/4 inches.
- Extra fine sandpaper.
Before Corbels InstallationYou can finish (paint or faux finish) corbels before or after installation.
After installation touch-up any area as needed.
Surface Preparation for Corbels Installation:
Clean all surfaces free of dirt and loose particles with a clean cloth or sponge.
Make sure area is completely dry before installing corbels.
Measure and mark the location where you want to install corbels.
General Corbels Installation
Lay the corbels face down on a surface that will not mar the product face, such as a clean cloth.
Follow good construction practices.
When using power tools, adhesive and finishing materials (such as paint or stain), be sure to follow manufacturer's instructions.
Always wear safety goggles when using a power tool or hammer.
Always use the right tool and/or equipment for the job.
|apply continuous bead of adhesive to edges of corbels|
apply pintable caulk to edges of corbels